Hot-Stuff™ Instant Adhesive

The great family of Hot-Stuff™ products has many uses in the shop and on the jobsite. This super-fast Instant Glue has been around for 39 years, but has only recently found its way into stone fabrication shops across the country. Similar to the fast-acting catalysts found in Cyanoacrylate-type glues, Hot Stuff, Super T and Special T are activated with a separate aerosol or pump bottle solution, with different formulas to regulate setting speed for your application. Several fabricator users have revealed that Hot Stuff is an extremely fast and cost-effective solution for retouching small scratches and repairing chips in most kinds of stone. As with all surface compounds and bonding agents, test a scrap area of stone with glue, and especially use care to avoid over-applying the spray or pump activator solution on light-colored stones. Just a few of the uses fabricators have found for Hot Stuff: ? Use to repair scratches quickly and neatly. Hot Stuff goes on clear and dries completely clear ? Patching and repairing chips on slab edges and tops. Using a costly and time-consuming repair method Try Hot Stuff and save time and money!

Repairing Stone with Hot Stuff?
Hot Stuff? goes on clear and dries completely clear, and comes in 3 viscosities?regular Hot Stuff? flows like water, while Super T? is the general thickness of syrup, and Special T? has the low flow and thickness of honey. Hot Stuff? quickly and easily repairs scratches. Just squeeze out enough Hot Stuff? to cover the scratch, apply activator, and immediately remove any excess with a razor blade. Lightly polish the area with extra-fine steel wool or a buff pad.

Pipettes Precision Glue Applicators
This new pipettes allow you to apply glue more precisely than ever before. To use them, unscrew the spout from the bottle. Squeeze the bulb of the pipette, insert the tip into the glue, then release the bulb. The pipette will suck up the glue. After making sure no glue is dripping, position the tip of the pipette where you want to apply the glue, and gently squeeze the bulb. In this way, you can squeeze out a single drop at a time more easily than with our spouts or even our Pro Tips.

When you are finished, squeeze all of the glue back into the bottle, and put the spout back on the bottle to seal it. You can rinse out the pipette with acetone or a little of the Super Solvent glue debonder to clean it and prevent clogging before your next use.